The equipped 2024 EV6 can supply up to 1.9 kW through Vehicle-to-Load and stops automatically when the high-voltage battery reaches the selected reserve.
Check that your vehicle has it.
Verified for 2024 U.S.-market Kia EV6 vehicles equipped with the exterior V2L connector. Kia's U.S. feature guide lists a maximum 1.9 kW output.
- Required equipment / service
- EV6 equipped with exterior V2L connector
Does the documented scope match your car?
This check combines the verified year, any source-supported powertrain scope, source-named trim/package and required equipment. It does not read a VIN or factory build record.
Published availability and qualifications
Verified for 2024 U.S.-market Kia EV6 vehicles equipped with the exterior V2L connector. Kia's U.S. feature guide lists a maximum 1.9 kW output.
Know what kind of control to look for.
This original category diagram is an orientation aid, not a picture of your exact trim. Use the written labels and your vehicle manual to identify the real control.
Step by step.
- 01
In the EV menu, open Vehicle to Load or EV Charge Transfer Settings and set the minimum battery level at which power should stop.
- 02
With dry hands, inspect the charging inlet, V2L connector and appliance plug for water, dirt, damage or corrosion.
- 03
Connect the compatible appliance to the covered outlet on the V2L connector, close its cover and insert the connector into the EV charging inlet.
- 04
Press the connector power switch and confirm its operating light illuminates before using the appliance.
- 05
To disconnect, switch V2L off, wait for the light to turn off, unlock the charging connector with the smart key if necessary and then remove it.
Important limits
- Do not use damaged, wet, corroded or ungrounded connectors and never handle the system with wet hands.
- Do not exceed the documented 1.9 kW output or use equipment requiring uninterrupted power, such as medical equipment.
- V2L reduces driving range and automatically stops at the selected battery reserve or during an overheat/overload condition.
Quick checks.
- ✓If the light stays off, ensure the reserve setting is below the current battery state of charge.
- ✓If a power-use warning appears, disconnect loads and verify their combined demand is below the system limit.
- ✓If the connector overheats, stop use, let it cool and inspect every contact before trying again.
What happened on your vehicle?
Your response is stored on this device. If you separately allow analytics, a non-account-linked guide/result event may also be measured. No VIN or personal information is requested.
2024 Kia EV6 Digital Owner's Manual — V2L How to Connect
Relevant section or page: Electric vehicle guide — Vehicle to Load. We use the written official source to determine the steps and applicability shown above.
View 1 supporting reference
Reviewed with a visible trail.
Scope and steps were checked by Car Cheat Codes Editorial Review. A guide is narrowed or corrected when the source does not support a broader claim.
- Published
- Last modified
- Source checked
Guide change history
- Initial verified publication.