Quick answer

Close every door except the liftgate, carry the electronic key, press the lower close-and-lock Walk-Away switch and move away while the dedicated buzzer sounds.

Before you start

Check that your vehicle has it.

Availability

Verified in the 2025 U.S. Grand Highlander gasoline owner's manual when equipped and enabled. Toyota notes that availability or activation can depend on vehicle configuration and customization.

Required equipment / service
Power back door, Walk-Away close-and-lock switch and electronic key, Gasoline equipped and configured for Close & Lock Walk-Away
Compatibility check

Does the documented scope match your car?

This check combines the verified year, any source-supported powertrain scope, source-named trim/package and required equipment. It does not read a VIN or factory build record.

Source-named equipment or service
  • Power back door, Walk-Away close-and-lock switch and electronic key
  • Gasoline equipped and configured for Close & Lock Walk-Away
Can you see the required control, menu or equipment on your vehicle?
Published availability and qualifications

Verified in the 2025 U.S. Grand Highlander gasoline owner's manual when equipped and enabled. Toyota notes that availability or activation can depend on vehicle configuration and customization.

  • 2025 Grand Highlander gasoline models with the Walk-Away power-back-door function
Visual orientation

Know what kind of control to look for.

This original category diagram is an orientation aid, not a picture of your exact trim. Use the written labels and your vehicle manual to identify the real control.

Cargo & utility orientation diagram for Toyota Grand Highlander
Cargo & utility orientationOriginal visual guide · controls vary by trim · not to scale
How to use it

Step by step.

  1. 01

    Close all side doors and leave only the power back door open, with the electronic key on your person.

  2. 02

    Press the lower close-and-lock Walk-Away switch on the open back door and listen for its distinct standby buzzer.

  3. 03

    Move away from the rear of the vehicle while the buzzer is sounding.

  4. 04

    Wait for the side doors to lock and the power back door to close and lock, then confirm the vehicle is secured.

!

Important limits

  • Standby is canceled after about 30 seconds, and approaching the vehicle again with the key can stop the sequence and unlock the doors.
  • Always visually confirm the liftgate closed and the vehicle locked; do not rely on the function around people or obstacles.
If it does not work

Quick checks.

  • ✓If standby does not begin, close every side door, carry the key outside the vehicle and press the Walk-Away switch again.
  • ✓If the sequence stops as you leave, keep the key away from the rear detection area and check the display for a power-back-door warning.
Owner feedback

What happened on your vehicle?

Your response is stored on this device. If you separately allow analytics, a non-account-linked guide/result event may also be measured. No VIN or personal information is requested.

Primary evidence

2025 Toyota Grand Highlander Owner's Manual — Close & Lock Walk-Away

Relevant section or page: Pages 122–123. We use the written official source to determine the steps and applicability shown above.

Open official source ↗
Editorial record

Reviewed with a visible trail.

Scope and steps were checked by Car Cheat Codes Editorial Review. A guide is narrowed or corrected when the source does not support a broader claim.

Published
Last modified
Source checked
Guide change history
  • Initial verified publication.