Quick answer

Set a V2L discharge floor, activate Utility Mode, open the indoor outlet and verify its indicator turns green before using a compatible device.

Before you start

Check that your vehicle has it.

Availability

Verified for 2025 U.S. IONIQ 5 vehicles equipped with the indoor Vehicle-to-Load outlet.

Required equipment / service
IONIQ 5 equipped with the indoor V2L outlet
Compatibility check

Does the documented scope match your car?

This check combines the verified year, any source-supported powertrain scope, source-named trim/package and required equipment. It does not read a VIN or factory build record.

Source-named equipment or service
  • IONIQ 5 equipped with the indoor V2L outlet
Can you see the required control, menu or equipment on your vehicle?
Published availability and qualifications

Verified for 2025 U.S. IONIQ 5 vehicles equipped with the indoor Vehicle-to-Load outlet.

Visual orientation

Know what kind of control to look for.

This original category diagram is an orientation aid, not a picture of your exact trim. Use the written labels and your vehicle manual to identify the real control.

Towing & power orientation diagram for Hyundai Ioniq 5
Towing & power orientationOriginal visual guide · controls vary by trim · not to scale
How to use it

Step by step.

  1. 01

    In EV settings, set the V2L battery-discharge limit below the current state of charge.

  2. 02

    With the vehicle in Ready and Park, activate Utility Mode for extended stationary use.

  3. 03

    Slide the indoor power-outlet cover open and connect the compatible device.

  4. 04

    Confirm the outlet indicator is green before using the device.

  5. 05

    Switch the device off and unplug it before ending Utility Mode.

!

Important limits

  • Do not use high-heat appliances such as kettles, toasters or irons inside the vehicle.
  • V2L stops when the battery reaches the selected discharge floor or an overload/overheat condition occurs.
  • Opening the charging door while indoor V2L is active can stop the discharging mode.
If it does not work

Quick checks.

  • ✓Lower the discharge limit if it is at or above the current battery level.
  • ✓Disconnect loads if the outlet indicator is red.
  • ✓End Utility Mode, inspect the plug and outlet, and retry only after an overheat condition has cleared.
Owner feedback

What happened on your vehicle?

Your response is stored on this device. If you separately allow analytics, a non-account-linked guide/result event may also be measured. No VIN or personal information is requested.

Primary evidence

2025 Hyundai IONIQ 5 Owner's Manual — Using Electricity Inside the Vehicle

We use the written official source to determine the steps and applicability shown above.

Open official source ↗
Editorial record

Reviewed with a visible trail.

Scope and steps were checked by Car Cheat Codes Editorial Review. A guide is narrowed or corrected when the source does not support a broader claim.

Published
Last modified
Source checked
Guide change history
  • Initial verified publication.