Quick answer

With the fob within 5 ft, lift the handle to unlock; close the entries and press the exterior handle button to lock, then wait two seconds before checking the handle.

Before you start

Check that your vehicle has it.

Availability

Verified for 2024 500e models equipped with Keyless Enter 'n Go Passive Entry.

Compatibility check

Does the documented scope match your car?

This check combines the verified year, any source-supported powertrain scope, source-named trim/package and required equipment. It does not read a VIN or factory build record.

Can you see the required control, menu or equipment on your vehicle?
Published availability and qualifications

Verified for 2024 500e models equipped with Keyless Enter 'n Go Passive Entry.

  • 2024 500e electric models equipped with Passive Entry
Visual orientation

Know what kind of control to look for.

This original category diagram is an orientation aid, not a picture of your exact trim. Use the written labels and your vehicle manual to identify the real control.

Key fob & access orientation diagram for Fiat 500e
Key fob & access orientationOriginal visual guide · controls vary by trim · not to scale
How to use it

Step by step.

  1. 01

    Keep a valid Passive Entry fob within 5 ft (1.5 m) of the front handle.

  2. 02

    Lift the handle to unlock the programmed driver-only or all-door selection.

  3. 03

    Close the doors and liftgate and keep the fob outside the vehicle.

  4. 04

    Press the Passive Entry button on either front handle to lock.

  5. 05

    Wait two seconds, then pull the handle to verify the vehicle stayed locked.

!

Important limits

  • Phones, laptops, gloves, water, snow, salt or dirt can reduce detection.
  • FOBIK-Safe can unlock and alert when it detects a fob left inside, but it is not a substitute for checking the key.
  • The system will not operate with a depleted fob battery.
If it does not work

Quick checks.

  • ✓Move the fob away from electronics and closer to the handle.
  • ✓Clean and dry the handle and confirm Passive Entry is enabled in Uconnect.
  • ✓Use the fob buttons and replace its battery if passive operation remains unavailable.
Owner feedback

What happened on your vehicle?

Your response is stored on this device. If you separately allow analytics, a non-account-linked guide/result event may also be measured. No VIN or personal information is requested.

Primary evidence

2024 FIAT 500e Owner's Manual — Passive Entry

Relevant section or page: Getting To Know Your Vehicle, pages 31–33 — Passive Entry. We use the written official source to determine the steps and applicability shown above.

Open official source ↗
Editorial record

Reviewed with a visible trail.

Scope and steps were checked by Car Cheat Codes Editorial Review. A guide is narrowed or corrected when the source does not support a broader claim.

Published
Last modified
Source checked
Guide change history
  • Initial verified publication.