Quick answer

On a 2024 Envista with the power liftgate, set the driver-door liftgate knob to 3/4, move the open liftgate to the desired height and hold its lower-edge button until the signals flash and a beep sounds.

Before you start

Check that your vehicle has it.

Availability

Verified for 2024 Envista vehicles equipped with the optional power liftgate and a driver-door liftgate mode knob. A manual liftgate cannot store a height.

Required equipment / service
Envista equipped with the available programmable power liftgate and driver-door mode knob
Compatibility check

Does the documented scope match your car?

This check combines the verified year, any source-supported powertrain scope, source-named trim/package and required equipment. It does not read a VIN or factory build record.

Source-named equipment or service
  • Envista equipped with the available programmable power liftgate and driver-door mode knob
Can you see the required control, menu or equipment on your vehicle?
Published availability and qualifications

Verified for 2024 Envista vehicles equipped with the optional power liftgate and a driver-door liftgate mode knob. A manual liftgate cannot store a height.

Visual orientation

Know what kind of control to look for.

This original category diagram is an orientation aid, not a picture of your exact trim. Use the written labels and your vehicle manual to identify the real control.

Power liftgate orientation diagram for Buick Envista
Power liftgate orientationOriginal visual guide · controls vary by trim · not to scale
How to use it

Step by step.

  1. 01

    Turn the power-liftgate mode knob on the driver door to the 3/4 position.

  2. 02

    Power-open the liftgate, stop it if necessary, and manually move it to the desired reduced height.

  3. 03

    Press and hold the close button on the bottom edge of the liftgate until the turn signals flash and a beep sounds.

  4. 04

    Close and reopen the liftgate in 3/4 mode to verify that it stops at the saved height.

!

Important limits

  • Set a height that clears people and cargo while remaining below any garage-door or ceiling obstruction.
  • Do not force the liftgate while it is actively power-cycling; stop the movement before adjusting it by hand.
If it does not work

Quick checks.

  • ✓If no beep or flash occurs, raise the liftgate slightly because the chosen position may be below the programmable minimum.
  • ✓If it still opens fully, verify the mode knob remains in 3/4 rather than the maximum-height position.
Owner feedback

What happened on your vehicle?

Your response is stored on this device. If you separately allow analytics, a non-account-linked guide/result event may also be measured. No VIN or personal information is requested.

Primary evidence

Getting to Know Your 2024 Buick Envista — Programming the Liftgate Height

Relevant section or page: 7. We use the written official source to determine the steps and applicability shown above.

Open official source ↗
Editorial record

Reviewed with a visible trail.

Scope and steps were checked by Car Cheat Codes Editorial Review. A guide is narrowed or corrected when the source does not support a broader claim.

Published
Last modified
Source checked
Guide change history
  • Initial verified publication.